Magnetic TRMNL Mount

Terrified by the Rapid Unscheduled Disassembly post in r/TRMNL, I decided to over-engineer my magnetic fridge mount. I drew inspiration from the open source mounts available on usetrmnl's github, but none of them satisfied my three requirements:The mount shouldn't be visible when viewing the TRMNL from the front.The mount should utilize as many of the rear mounting points as possible.The magnets should be embedded within the mount to remove any risks around adhesion or tension fits.My magnetic mount utilizes the existing triangular mounting points at the top of the display, and repurposes the two side holes used for the swivel stand as well. 2 M2x12 nuts and bolts are used to secure the mount to the rear of the display, and a triangular insert slips into the top mounting points. Additionally up to 14 6x2mm circular magnets can be embedded within the print. I used all 14 and this thing isn't going anywhere. I will most likely release an update in the future which is thinner