Magpul M-lok System Components

All of these variations are BASED on the M-LOK system by Magpul.

Please support the DEVs
https://www.magpul.com/search-results?PID=88&eComQuery=mlok&ProductNumber=mlok

I have included the 3, 5, 7, 9, and 11 Slot rails. I plan on developing the Cantilever and other commonly used mounts as well. I have used 8-32 (1/2" or 3/4" round [button] head) (3/4" or 1" flat [countersunk] head) phillips head screws and nuts to secure these to my hand guard. A 10-32 1/2" or 5/8" screw will work but may require some additional material removed from the rail so the screw can pass through the rail. A 10-32 will grab the included T-nut quite well from testing. A Hex nut may be large enough to allow for modification so that some material from the mating face can be removed and allow for it to lock into the rail with an oval footprint.


** I used a #10-32 x 3/4" flat head phillips(countersunk) for use with the tnut. as you can see in the photos there is a bit of thread left over so shorter is