MagSafe 2 cable saver

MagSafe 2 cable strain relief. This should be printed in PETG or ABS. It can be printed on the back with a tiny amount of support. The round holes shouldn't require any but there is a tiny amount of overhang. Id paint the supports out for the holes and just allow a tiny amount for the over hangs. If you're not bothered, it can be printed without any support but there might be a few strings from the unsupported part in which case a small file or drill bit could be used to clear out the holes. The zip tie can be recessed if using a small one. A zip tie may not be needed but its likely a good idea to add one to stop the strain relief from being lost if it gets loose. Ive shown a previous version on the print bed which shows the best orientation for printing. I have uploaded a second version which has had some of the clearance reduced. It fits our connector as a "push fit" and should stay on the connector without a zip tie being needed. The only snag with this version is that it was made t