Thingiverse
MagSafe charger Cable tip replacement
von Sebby5
9
Downloads
9
Likes
0
Makes
Here's a replacement Tip in case you want to repair the cable of your MacBook charger, just like I did.
It's made out of two halves which clamp the cable tight in the adapter casing, to prevent any movement inside.
The halves are scaled a bit, for width compensation during printing.
If you don't want or need the compensation for printing. Scale the width of the tip down by 4%
The parts can be printed without supports.
It's made out of two halves which clamp the cable tight in the adapter casing, to prevent any movement inside.
The halves are scaled a bit, for width compensation during printing.
If you don't want or need the compensation for printing. Scale the width of the tip down by 4%
The parts can be printed without supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
