Magsafe charging stand

A simple charging stand suited for an existing standard and two watch MagSafe connector to show off iOS 17's new ‘StandBy’ feature. --Features-- Horizontal display angle for phone charger so it can be seen easily on a bedside table while laying down The base comes in two parts with 10x 12mm holes to insert small fishing sinkers to weigh down the base (optional) All parts slot together well without the need for glue, feel free to add some if desired Pinhole on the back of the charging slots to assist in pushing out the charger if required All cables are routed through the stem of the stand so they cannot be seen Cable track on the underside to allow the base to be placed flat and cables exit from the rear of the stand Can mix and match which charger blocks are used in each position --Assembly-- Fill the circle holes in the base with weight (optional) Align the upper and lower bases and push together Push the stem piece into the base Slot each magsafe charger into its charging block Feed