Magsafe Heltec V3 Lora / Meshtastic Case

This is a Heltec V3 case that is very common within the Meshtastic and LoRa community. It snaps onto the back of your phone by utilizing magnets embedded in the print and is powered via USB C cable from the phone (Make sure your phone supports reverse charging first). Assembly is very simple, and requires no external hardware other then the magnetic ring which can be found here https://www.aliexpress.us/item/3256806058016581.html?spm=a2g0o.order_list.order_list_main.22.3ff11802IPVJrx&gatewayAdapt=glo2usa , and the Heltec Board with an SMA connector. In order to embed the magnetic ring into the print, It is necessary to print at a .2mm layer height with a .4mm nozzle and then pause the printer at layer number 6 or 7. Then make sure the magnet is oriented with the correct side facing down (Test on the phone before hand) finally peel the film of magnets and stick the magnets to the inside gap of the print, in order for the model to stay compact you have to remove 3 magnets from the ring a