Thingiverse
Magsafe Shelf
door _benjamin_
3
Downloads
0
Likes
0
Makes
ATTENTION!
SCALE UP THE PRINT CUZ:
In my expirience:
The print was too small on first try. I had to sand down the print and then squeeze the Magsafe in with force. Scale it up a couple of % with you slicer and might be fine.
its my first upload so bare with the roughness
i stole stuff from off of these designs (the remix feature wouldnt work/i'm lil dumb)
https://www.thingiverse.com/thing:4715951
https://www.thingiverse.com/thing:4697960
SCALE UP THE PRINT CUZ:
In my expirience:
The print was too small on first try. I had to sand down the print and then squeeze the Magsafe in with force. Scale it up a couple of % with you slicer and might be fine.
its my first upload so bare with the roughness
i stole stuff from off of these designs (the remix feature wouldnt work/i'm lil dumb)
https://www.thingiverse.com/thing:4715951
https://www.thingiverse.com/thing:4697960
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!