Magsafe switch mount.

I designed this simple MAGSAFE mount to fit into switch blanks found on most SXS vehicles like the Polaris RZR or Can-Am. This is designed for a Kaistyle Magsafe mount that is found on Amazon. I have done some high speed trail testing and it held position just fine but I would not use it for hard core hills. For printing. YOU MUST PRINT AT AN SIDE ANGLE! Failure to do so will cause the print to fail along the layer lines. Not responsible for broken or lost phones. Print PETG at a minimum. To assemble you will need to remove the two screws from the bottom of the mount. There is a small spring loaded ball that may fall out. It is not needed so don't worry if it or the spring is lost. If you have children or pets make sure they don't swallow it. Line the holes up and screw it back down hand tight. Yes I am aware the “ring” is flimsy, it is more decorative than anything. If your clips don't print perfectly then put the good ones at the top. Boost MeSXS aren't cheap, throw a