Thingiverse
Electronics
Model downloaden
MagTag Case & Stand
89
Downloads
61
Likes
1
Makes
This case is designed to protect the MagTag. It features cutouts for the four user buttons, USB-C, and on/off switch. The reset and DFU side buttons feature reliefs that allow the overlays to actuate the switches. Use vinyl to create covers with beautifully glossy holographic decals.
Want to prop up the MagTag on your desk? This simple 3D printed stand mounts the MagTag at a 70 degree angle for perfect viewing. The wide bottom prevents the stand from tipping over. An hole in the lower center allows a STEMMA cable to pass through for connecting other I2C sensors.
Adafruit MagTag
https://adafru.it/4800
420mAh Battery
https://www.adafruit.com/product/4236
M3 Magnet Feet
https://www.adafruit.com/product/4631
Learn Guide for Assembly Photos
https://learn.adafruit.com/magtag-3d-printed-stand-case/
Want to prop up the MagTag on your desk? This simple 3D printed stand mounts the MagTag at a 70 degree angle for perfect viewing. The wide bottom prevents the stand from tipping over. An hole in the lower center allows a STEMMA cable to pass through for connecting other I2C sensors.
Adafruit MagTag
https://adafru.it/4800
420mAh Battery
https://www.adafruit.com/product/4236
M3 Magnet Feet
https://www.adafruit.com/product/4631
Learn Guide for Assembly Photos
https://learn.adafruit.com/magtag-3d-printed-stand-case/
adafruit publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
