MaixCAM Pro Front Camera Bracket

这个打印件可以帮助你将MaixCAM Pro标配的镜头翻转180度，不需要额外的螺丝，但是需要自行购买22P 0.5间距的同面FPC延长线和一个对接座，将延长线接在机器自带的黄色排线和PCB的FPC座子之间即可。然后将机器正面四个角上的其中两个螺丝取下，用于固定摄像头模组和翻转支架，然后将原来用于固定摄像头模组的稍长的螺丝拿来固定打印件到PCB上。强烈建议使用PETG打印，因为摄像头的温度容易让PLA软化。它兼容GC4653以及04A10，并且有足够的空间安装超广角镜头。 另外，你还需要进入系统内的"/boot/board"文件，编辑"cam_flip"和"cam_mirror"两项配置为1，否则画面会是反转的 This printed part can help you flip the lens that comes standard with the MaixCAM Pro by 180 degrees without the need for additional screws. However, you will need to purchase a 22P 0.5mm pitch same-side FPC extension cable and a connector. Connect the extension cable between the yellow ribbon cable that comes with the machine and the FPC socket on the PCB. Then, remove two of the screws from the front corners of the machine to secure the camera module and the flip bracket, and use the slightly longer screws that were originally used to secure the camera module to fix the printed part to the PCB.It is strongly recommended to use PETG for printing, as the tem