Slicer Discord
Make Unitrack to Unitram (n-gauge) – 3D-printbaar model van MakerWorld MakerWorld
Vehicles

Make Unitrack to Unitram (n-gauge)

44 Downloads
22 Likes
17 Makes
Model downloaden
You have S186-tracks of Kato’s Unitrack, but need Unitram-double track plates for your layout? Here is the solution, inlets for filling the gap.Have fun! Please note:“Kato”, “Unitram” and “Unitrack” are trademarks of K.K. Sekisui Kinzoku, Japan and are used for reference only. The design presented here is neither supported nor authorised by the before mentioned trademark holder. Please not the license:This design is published under the CC BY-NC-SA license, which means that you can freely use this model for any non-commercial purpose and may remix this model freely as long as you provide attribution to the designer and share with the same creative commons license. Feel free to contact me if any questions.
Categorie
Vehicles
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Slanjonok publiceert ook op

248 extra modellen op 3 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie