Thingiverse
Maker Coin Benchmark Tester
door HappyGilmore
9
Downloads
3
Likes
0
Makes
This is a Benchmark test coin that can check tolerances for individual filaments.
The coin allows you to:
*Check tolerance for M5, M3 nut, M5/4/3/2 threads
*Check single extrusion width
*Check 1mm Wall width
*Check bridging capabilities
*Check support adhesion
*Make side by side comparison using the joints on the outside Diameter
*Locks together with other coins when stacked
* has enough surface area around circumference to add sticky label.
The coin allows you to:
*Check tolerance for M5, M3 nut, M5/4/3/2 threads
*Check single extrusion width
*Check 1mm Wall width
*Check bridging capabilities
*Check support adhesion
*Make side by side comparison using the joints on the outside Diameter
*Locks together with other coins when stacked
* has enough surface area around circumference to add sticky label.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
