Maker Select v2 Cable Chain Mounts

I bought a Maker Select v2 in September of 2017 and didn't like the way the y-axis wiring just kind of floats around waiting to get pinched between the table and the frame. Found a cable chain here (close relative of the MSv2) https://www.thingiverse.com/thing:2221459), for a Wanaho printer, but for some reason the plate mount and frame mount were off in alignment by a centimter or so. Also, the other plate mounts I found, which may have worked, did not take into account the location of the soldered wires on the bottom of my heated bed. Figured this was due to some design change between the two printers or versions so modeled up my own which fit the MSv2. If you print my two models to make this project, you will also need the UM2CableChain_Lid_75percent.stl and UM2CableChain_ChainSegment_75... from this project: https://www.thingiverse.com/thing:1459160/#files. Be sure to print these with support material "everywhere" in Cura.