Thingiverse
Maker Select V2 Spool Holder
door Nottim
19
Downloads
14
Likes
1
Makes
As most owners of the Maker Select V2 have probably noticed, the provided spool holder is too thin for most filament spools. This design extends the provided holder by about 2cm, making it plenty big for most rolls. It has a semi-rounded top for low friction against the roll, a key for ensuring the part stays in place, and a flared bottom to fit snugly into the stock filament holder.
To install, unscrew the nut holding the stock holder, turn the stock holder over, and slide the printed part into the groove from the side. Insert the key into the hole in the printed holder.
To install, unscrew the nut holding the stock holder, turn the stock holder over, and slide the printed part into the groove from the side. Insert the key into the hole in the printed holder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
