Thingiverse
Makerbot 2 Filament Guide
von crossfactor
1
Downloads
2
Likes
0
Makes
Filament clip to hold on to the electrical wires going to the heater , It replaces the makerbot clear tube guide.
There are 2 holes going around the body so the clip and filament can be secured with a wire (may not be necessary but nice to have)
**
Edit this design still doesn't prevent my filament from breaking , so some refinement is needed
There are 2 holes going around the body so the clip and filament can be secured with a wire (may not be necessary but nice to have)
**
Edit this design still doesn't prevent my filament from breaking , so some refinement is needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!