Thingiverse

MakerBot Replicator 2 Tablet & GoPro Mount

by Mrautobot

12 Downloads

9 Likes

0 Makes

I made this mount to be able to use your iPad, tablet, or GoPro to live stream or time-lapse what is being printed on my MakerBot Replicator 2 when I am not present to monitor it or want to record a timelapse of the print. The mount is intended to be put on the middle of right front corner of the printer by taking out the middle front and side hex bolts on that corner(swapping them out for slightly longer hex bolts(M6-1.0 x 18 mm) and threading the bolts through the print as shown. I have used a GoPro, mainly to make a timelapse, but I primarily use my iPad Air with the Manything streaming app so I attached kaneda_fr's [print](www.thingiverse.com/thing:2629727) for the iPad Air/ tablet holder that will attach to this mount.

I included the list of all of the hardware below. If you already have a GoPro then you probably have their standard adjuster Philips head knob and a cap nut. For the tablet mount from kaneda_fr I didn’t have a case for my iPad Air and wanted to tighten the hold o

accessories accessory camera camera mount feed filming filming rig gadget gadgets gadgets3d GoPro gopro hero 3 gopro hero 4 GoPro Mount gopro session mount iPad iPad Air iPad Stand Livefeed livestream accessories accessory camera camera mount feed filming filming rig gadget gadgets gadgets3d GoPro gopro hero 3 gopro hero 4 GoPro Mount gopro session mount iPad iPad Air iPad Stand Livefeed livestream

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format