Makerbot Replicator Mini+ (plus) Spool Holder and Filament Guide
par dirkvranckaert
32
Téléchargements
29
Likes
0
Makes
The spools that fit the Makerbot Replicator Mini + (plus) are small and sometimes you want to hook up the machine to larger spools, but unfortunately these won't fit in the machine. This spool holder solves that for you with an easy clip to stick on the back of your Makerbot.
There are three spool holder designs:
1. Compatible with all spools but the spools do not greatly fit because they are sitting loose...
2. Compatible with all spools, also wider spools up to an 80mm width. Still they are sitting loose...
2. A 50 millimetre design for spools with a 50 mm hole just to fit better. Together with this design comes a pin with which the spool can be tightened on the spool holder. Two pin holes for spools with a total thickness of 70 and 80 mm are foreseen! For smaller spools you should be able to drill a 4mm hole in the spool holder.
And two filament guide designs:
1. When using the loose-spool-holder, it's smaller and there is still plenty of room to attach the normal filament
There are three spool holder designs:
1. Compatible with all spools but the spools do not greatly fit because they are sitting loose...
2. Compatible with all spools, also wider spools up to an 80mm width. Still they are sitting loose...
2. A 50 millimetre design for spools with a 50 mm hole just to fit better. Together with this design comes a pin with which the spool can be tightened on the spool holder. Two pin holes for spools with a total thickness of 70 and 80 mm are foreseen! For smaller spools you should be able to drill a 4mm hole in the spool holder.
And two filament guide designs:
1. When using the loose-spool-holder, it's smaller and there is still plenty of room to attach the normal filament
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !