Thingiverse
MakerBot Watch
door MakerBot
64
Downloads
96
Likes
2
Makes
This kit is hard to make! It's SMD soldering and it's freaking hardcore. We're selling them at just a little bit more than cost because this is for alpha users!
We're going to go into production on these and they will come mostly assembled. We are just selling these as alpha kits.
There is no guarantee or warranty at all. Bre has made four of them and three of them required a lot of fussing with the soldering until he got rid of all the solder bridges.
Specs:
* Atmega328 chip with Arduino bootloader on it.
* 6 pin header for bootloading. Also includes access to 4 I/O pins and power and ground
* 6 pin header for programming.
* 4 pin extension header for plugging in other things like sensors or shields that extend the watch.
* 16mhz crystal.
* Piezo buzzer
* 3 pushbutton switches
It has 12 LEDs to mark the hour and 12 LEDs to mark the 5 minute marks plus an extra 4 LEDs to mark the 4 extra minutes that aren't shown. So if it was 12:04 the
We're going to go into production on these and they will come mostly assembled. We are just selling these as alpha kits.
There is no guarantee or warranty at all. Bre has made four of them and three of them required a lot of fussing with the soldering until he got rid of all the solder bridges.
Specs:
* Atmega328 chip with Arduino bootloader on it.
* 6 pin header for bootloading. Also includes access to 4 I/O pins and power and ground
* 6 pin header for programming.
* 4 pin extension header for plugging in other things like sensors or shields that extend the watch.
* 16mhz crystal.
* Piezo buzzer
* 3 pushbutton switches
It has 12 LEDs to mark the hour and 12 LEDs to mark the 5 minute marks plus an extra 4 LEDs to mark the 4 extra minutes that aren't shown. So if it was 12:04 the
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
