Thingiverse
Makerbox Replicator 2X Duct Fan
por clearchrome
2
Descargas
0
Likes
0
Makes
Redesigned the filament Duct Fan to be able to print PLA.
No screws and no other special hardware needed.
The fan is not hitting the enclosure door as original design.
I used a Glue Gun the fan & holder and works very well
You can get yourself those special long hex screw if you are worried about not holding up.
Print it on the Side, tested on long term ,works great.
No screws and no other special hardware needed.
The fan is not hitting the enclosure door as original design.
I used a Glue Gun the fan & holder and works very well
You can get yourself those special long hex screw if you are worried about not holding up.
Print it on the Side, tested on long term ,works great.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
