MakerChip Bandolier

*****2/22/2026 V2 has been added***** V2 has the connector integrated into the bandolier sections, at the bottom end. Less to connect and potentially fail. This does shorten the length of each section by 1. But it's a good tradeoff. Introducing the MakerChip Bandolier.A fun way to handout and collect MakerChips while at festivals.Each slot holds 2 MakerChips. 1 fits snuggly into the base and the 2nd clips in and sits on top of the other one.The X/P/A profile is designed for a 256x256 plate. The H2 profile allows an extra set of rings, 6 vs 5 sets.Each plate has the set of preconnected rings and a connector V2. Connector V1 is on a separate plate for each left and right.The connectors use a small amount of supports and these must be removed for the loops to be open. You may need to snip off some of that to open the loop enough to catch the opposite end when attaching together. See photo with the areas circled. I printed the left bandolier on my H2D and the right one on my X1C. I pri