Makerfarm e3d dii cooler

i wanted a dii cooler for my pegasus... there were no good mounts imo, so i made one.

Here is what i made in one night, it works fine. just remove the wood piece, and put this in the same place, make sure the cooling fan is faced up, and away from the wires on the heater block.

Follow the same directions for the diicooler that you would normally except get longer mounting screws 20mm is what i used with a diameter of 3mm.

If you print this, post pics id love to see what you guys come up with!

Also im not done, but im out of time at the moment, future plans are to smooth out the sharp corners and make it easier to print, and maybe add a couple speed holes to it.

NOTE! This will not work with anything but the Makerfarm extruder, if you have the titan or any other changed ones, i can not guarantee it will work!