Slicer Discord
Makergadgets Innovator Wire Plug – 3D-Druckmodell von Thingiverse Thingiverse

Makergadgets Innovator Wire Plug

5 Downloads
1 Likes
0 Makes
Zum Modell
This is a wire management hole and PTFE passthru for the Makergadgets Innovator enclosure. The plug fits the roughly a 1 3/8" in the back left of the enclosure, sealing it off but letting wires through.

Two pneumatic connectors screw in each side with a PTFE coupler between them. This lets you keep dryboxes with heat-intolerant materials stay outside of the enclosure, along with your electronics.

This needs to be printed in TPU for the flexible flaps to work. TPU is also heat-tolerant enough for inside of the enclosure.

Assembly requires 2 M3 x 16mm screws and 2 M3 nuts.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
TPU
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

jonspaceharper veröffentlicht auch auf

30 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

2 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen