Makergear M2 Duet Electronics Conversion Project

#####Please Note: This Project is very much a work in progress, I will update it when I can. Thanks for being patient!

---

#Welcome to my project to bring the
#Makergear M2 up to date with
#the Duet WiFi / Duet Ethernet

---

###Here you will find what you need to do your own upgrade on your M2, I'm basing this project around several parts which you see listed below.
---
####Part One: Adapter rails; so your Duet can take the place of the RAMBo Board
>>Print both adapter rails. These adapter rails fit over the old mounting points that the RAMBo board used. Save the four screws that attached the RAMBo to the M2 frame and use those to screw down the printed adapter rails. The adapter rail that has the indent goes on the right side to avoid a protrusion that would otherwise block the rail.

>>Use four 8mm M3 screws to secure your Duet to the printed adapter rails. The M3 screws should just thread into the plastic of the adapter rails.

>>Current revision 1.1 - Please r