Thingiverse
Makergeeks Spool Hub
von mcolangelo
3
Downloads
1
Likes
0
Makes
Simple filament spool hub (tested on Makergeeks spools)
57.5mm OD
21mm ID
10mm thick
Added some small tabs on the face to prevent it from getting pushed in too far.
Works well on a 3/4" axle
57.5mm OD
21mm ID
10mm thick
Added some small tabs on the face to prevent it from getting pushed in too far.
Works well on a 3/4" axle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
