Makerplane Handlebar Case

Case to mount a Makerplane Sunlight Readable Display on 31.8mm bars. Previous case to house the Pi and display was bulky so this is designed to house the display only, in the minimum possible space. It is designed to be as waterproof as possible. The display; http://store.makerplane.org/5-sunlight-readable-touchscreen-hdmi-display-for-raspberry-pi/

There are two versions; one has a down-facing spout that fits a simple glue-in-place tpu gasket for cabling.
The other (V3/GX16) has a plain hole for a panel-mount waterproof GX16 aviation connector for the GPIO's. There is a slot in this hole, so that you can pass through an HDMI cable before installing the GX16 connector. Then you can insert the GX16 wedge gasket, which is 1mm higher than the depth of the slot-- when you tighten down the GX16 connector this gasket will press against and seal the HDMI cable in its slot.

There are 2 other TPU gaskets for both versions; one for the display bezel, and another for the front/back case s