Thingiverse
Malt Mill mount and box
door Naesstrom
1
Downloads
1
Likes
0
Makes
Mount for a windshield wiper motor and box for electronics.
Distance from bottom to center of motor pin is 68mm so you might need to adjust it to your grain mill.
c/c on the holes of the motor is 40mm
## Here are links for the parts
* Motor: https://www.skruvat.se/show.aspx?k=17363
* Coupler:https://banggood.app.link/fuxLbYwZAeb (10mmx12mm)
## Then you can source the following wherever:
* m6 extension nut (m6x30) where you file half of it round to fit in the coupler
* XT60 connector between box and motor
* Circular power switch 20mm diameter _(or larger if you want to drill)_
* dc powerjack (https://banggood.app.link/gM6wD2KAEeb)
* 3x m6x30 _(fasten motor to mount)_
* 2x zipties _(fasten box to motor)_
* 5x woodscrews _(fasten mount to millplate)_
Distance from bottom to center of motor pin is 68mm so you might need to adjust it to your grain mill.
c/c on the holes of the motor is 40mm
## Here are links for the parts
* Motor: https://www.skruvat.se/show.aspx?k=17363
* Coupler:https://banggood.app.link/fuxLbYwZAeb (10mmx12mm)
## Then you can source the following wherever:
* m6 extension nut (m6x30) where you file half of it round to fit in the coupler
* XT60 connector between box and motor
* Circular power switch 20mm diameter _(or larger if you want to drill)_
* dc powerjack (https://banggood.app.link/gM6wD2KAEeb)
* 3x m6x30 _(fasten motor to mount)_
* 2x zipties _(fasten box to motor)_
* 5x woodscrews _(fasten mount to millplate)_
Naesstrom publiceert ook op
33 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!