Malyan M150 Knob

I got sick of the original plain, round knob style after using a Prusa Mk2, which has the extra bit that lets you spin it with your finger. The original knob also kept bottoming out against the face plate, so I was frequently pulling it back out to to be able to push again and make selections.

I printed this so long ago that I don't remember the settings, but it's hard to go wrong with this one. Supports not required, but I think I added a brim to ensure adhesion. Might have had to bore the inside a little bit to fit, but I'd rather have it on too tightly than too loose.

I'm sure this works with other printers too, but don't have the means to verify if and which ones.