MamaRoo Mobile Attachment Piece Replacement

The mobile attachment arm on our mamaroo broke. I put the pieces together and glued but it couldn't hold, so instead I recreated it and printed it. After 3-4 attempts I finally got the orientation the right way so it holds.

The white plastic picture is the original broken piece. The orange is the replacement. The last picture is it holding the mobile up.

Print sideways in orientation. If you try to rotate it it splits along the layers or fractures completely. PLA was too weak and slowly bent over time until failing. I ran out of ABS so I printed in PETG which so far is holding.