Thingiverse
Mamiya TLR Body Cap
by SubsonicMike
2
Downloads
4
Likes
0
Makes
Based off the body cap by Sagrotan, I found the cap to be slighty too big on my Mamiya C330 and redrew some of the profile to not catch on the cocking leaver or shutter leaver.
Whilst redrawing I also decided to make the cap more faithful to the original adding the Mamiya name. I also added two rings on the back of the cap which help aid alignment for quick fitment.
For printing:
Print 1 cap and 2 rings then glue the rings into the grooves on the back of the cap.
Supports are not nessesary, you might have to enable bridging.
Enable print thin walls is turned on to make sure the Mamiya text doesnt get lost.
I printed in PLA+ at 0.16mm layer height for the Cap and 0.12 for the rings
Whilst redrawing I also decided to make the cap more faithful to the original adding the Mamiya name. I also added two rings on the back of the cap which help aid alignment for quick fitment.
For printing:
Print 1 cap and 2 rings then glue the rings into the grooves on the back of the cap.
Supports are not nessesary, you might have to enable bridging.
Enable print thin walls is turned on to make sure the Mamiya text doesnt get lost.
I printed in PLA+ at 0.16mm layer height for the Cap and 0.12 for the rings
SubsonicMike also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!