MAN-KAT 1

This is the cabin of the MAN KAT1, draw from scratch, based on 4 drawings i found on internet.
fits on the frame v4 of Mr CranckyFace (see https://www.thingiverse.com/thing:2935751)


- The roofpin need to be made 3 times.
- The prarewheelpin need to be printed 2 times.

- Bottom 1 is on the front side, than 2 etc. following the lines of the outer parts.
i used "fittingblock 1, 3 and 5" in order to have the correct hight from the bottom of the front door , the middle part of the wheel case and the bottom of the last part of a side.
(See picture). The square blocks are the fitting blocks)

note for printing :
- Roof plates, 26.195 deg
- Front bottom plate + light protection and attchementeyes : 50 deg

- Seats: https://www.thingiverse.com/thing:42443, chopped the base off scaled 1.5 in all directions (added the modified file)
- SeatBase https://thingiverse.com/thing:3468514, used chopped seat-base. Print at x82deg (added the modified file)
- Printed with seat-ba