Thingiverse
Mandalorian Ear savers
by feanorgem
114
Downloads
73
Likes
0
Makes
This is a colored, by layer, Mandalorian logo ear savers. It is set up to use a common configuration using the Multi-Material 2S but could be printed by swapping filaments at the layer changes on a single color printer. The color load pattern 1-5 is: blue, red, yellow, white, black but it only uses three. File names containing "Top" print two copies on the top half of the print bed while those containing "Bot" print two copies on the bottom half of the print bed, thus you can run any combination of Top and Bot without removing anything from the print bed. You can increase the quantity printed by adding more instances and arranging them so they fit.
feanorgem also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!