M&P SHIELD Flat-Curve Trigger

Liked the idea of the flat trigger made by Wagner_Developments but needed a little work/modifications so it would sit in the frame to correctly orient the trigger bar. If the trigger was printed/finish sanded too thin the trigger bar would not ride correctly under the sear. The cut-out on the right side has been modified to closer mimic the factory. I also curved the front face just a tiny it as to be a little more ergonomic and added some "zev" style cuts as I wasn't too fond of the original bulky look.


***NOTE***
After printing I always manually drill properly sized pin holes and finish sand flat surfaces with 320 grit sandpaper and 800 for surfaces that are in contact with the frame as to cut down on friction.


This is for proof of concept only. I am not responsible for any damage or weapon failure due to this model.