Manscape Organizer

I designed this to fit an OUTLET SHELF so it has an open back for the power cord to fit through the shelf opening into the outlet. ( I also took OFF the letter 'D' on the side )


+ Minimal support material that removes easily but does use bridging so keep that in mind.
+ I'm using .12mm Layer Height and a Brim to help with bed adhesion
+ 15% Infill
+ 6 Bottom layers and 6 Top layers
+ 3 Outer walls


I accidentally ran out of black filament and changed to grey, if you like the 2 color look, I switched colors around 53% through the print. Or where the incline is Flush with the base.





Feel free to use any settings in your slicer you prefer, this is how my printer is set up and turned out fine.