Thingiverse
Manual Bed Leveler
von Goulet
2
Downloads
2
Likes
0
Makes
Resize this to fit about the size of your print bed leave about an inch or two from each side and print with no bottom layer and watch your print head to make sure it is about the same level around each corner of the print. This is for manual hot bed adjustments like in the Anet A8 where you have to adjust springs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!