Thingiverse
Manual Counter
von NeoStellarator
12
Downloads
6
Likes
0
Makes
A **manual counter** constituted of 13 support-less printable parts. A decagonal prism (with 17.5mm sides) is rotated to show on a window a number.
Things to print:
- X1 SUPPORT.STL
- X1 of each number (0 - 9.STL)
- X2 NUMBER_HOLDER.STL
It may be extended with further counters arranged side by side. To do so, the set of parts must be reprinted and two Ø 2.5mm or Ø 3mm stick inserted in the holes in the SUPPORT part.
How to assemble:
Place each number (in order) inside each slot of one NUMBER_HOLDER part. Then place the second NUMBER_HOLDER part on the other side, inserting each number in its corresponding slot.
No glueing is necessary: all pieces attach swiftly.
** To improve visual quality, it is recommended print/paint the numbers in a different colour.
Any issues or suggestions, please comment on the thing.
Things to print:
- X1 SUPPORT.STL
- X1 of each number (0 - 9.STL)
- X2 NUMBER_HOLDER.STL
It may be extended with further counters arranged side by side. To do so, the set of parts must be reprinted and two Ø 2.5mm or Ø 3mm stick inserted in the holes in the SUPPORT part.
How to assemble:
Place each number (in order) inside each slot of one NUMBER_HOLDER part. Then place the second NUMBER_HOLDER part on the other side, inserting each number in its corresponding slot.
No glueing is necessary: all pieces attach swiftly.
** To improve visual quality, it is recommended print/paint the numbers in a different colour.
Any issues or suggestions, please comment on the thing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!