Thingiverse
Maple Twist - Single Extruder
von bugman_140
43
Downloads
35
Likes
1
Makes
Here is my Model for the Maple Twist,
This was requested by my friend @_Tinkerz on Twitter as he had some colours that were screaming to him to be printed as a leaf.
The model is designed to be printed separately allowing for up to 3 different colours to be used. The Photos (Supplied by @_Tinkerz) Thank you.
After Feedback I was told that the fit was a little tight, so I have increased the tolerance to allow it to slide together, i have however left the tighter version online for if you want to scale it up.
Enjoy
This was requested by my friend @_Tinkerz on Twitter as he had some colours that were screaming to him to be printed as a leaf.
The model is designed to be printed separately allowing for up to 3 different colours to be used. The Photos (Supplied by @_Tinkerz) Thank you.
After Feedback I was told that the fit was a little tight, so I have increased the tolerance to allow it to slide together, i have however left the tighter version online for if you want to scale it up.
Enjoy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
