Thingiverse
Marble Maze
von CJ4000
6
Downloads
4
Likes
0
Makes
This marble maze is one of my first designs. You can start at either end. The lid fits into the base, though you may need to sand it down a bit. I don't expect this project to get much attention, but if it does i will adjust the pegs to fit better and make all the different parts separate files.
If you have a marble of the right size, you can use that rather than the 3d printable one i included. Only use supports if you want the marble to turn out well. If you have your own no need to.
If you have a marble of the right size, you can use that rather than the 3d printable one i included. Only use supports if you want the marble to turn out well. If you have your own no need to.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!