Slicer Discord
Marble Run Challenge - Lego Compatible – Modèle 3D imprimable de MakerOnline MakerOnline
Marble Run Challenge - Lego Compatible – Bild 1 Marble Run Challenge - Lego Compatible – Bild 2 Marble Run Challenge - Lego Compatible – Bild 3 Marble Run Challenge - Lego Compatible – Bild 4 Marble Run Challenge - Lego Compatible – Bild 5 Marble Run Challenge - Lego Compatible – Bild 6
Education

Marble Run Challenge - Lego Compatible

255 Téléchargements
103 Likes
0 Makes
Voir le modèle
Use these parts to create a marble run for 10mm marbles.  The tracks and other components are compatible with Lego building blocks.  But you are not restricted to using Lego compatible blocks.  There are parts specifically for joining the other pieces without the use of Lego blocks.  There are even adjustable trestles and beams that can be used to support your construction. Science Olympiad These models should be fully compatible with the Science Olympiad challenges. The marble run pictured above would be fully compatible with the Science Olympiad. Unfortunately, at the time of this picture it is 12 seconds too fast. The above layout includes: One - Starting Block One - Finish Block Three - Beams Two - Trestles One - Third order Hilbert curve (mounted on top of one of the beams) One - Fourth order Hilbert curve One - Cone and Cone-Sluice One - Loop Several columns (mainly to save on the number of Lego bricks used) Two inline catchers Various straight and curved rails Rail fasteners (for long spans) Pictured above are two jumps (Science Olympiad compatible). Printing Before printing, make sure that your printer is calibrated for X, Y, and Z.  Please make sure that your bed is level (trammed) and that you have adjusted to remove any Elephants foot.  Then print the included “Lego-Like 2x3” model.  Make sure that it will interface with “real” Lego bricks without being too tight or too loose. Suggested Settings: No Supports (see below for exceptions) Thin Walls (this is important for built-in supports and other Lego compatible features) Wall Ordering: Outside to Inside 3 Walls (2 if using 0.6mm nozzle) 3 Top and Bottom Layers Lightning Infill Supports Needed: Ramp-up-xxx and Ramp-down-xx Loop-Clothoid-Main - must be printed on its side with supports. Change History 2023-03-25: Tune for 0.6mm nozzle 2023-03-24: Update pretty much everything so all parts fit better with real Lego bricks. Lots of neat new parts. 2023-03-22: Update the Hilbert-Curves so they are a bit tighte
Catégorie
Education
Source
MakerOnline
Publié
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Marble PLA
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

grizzie17 publie également sur

350 modèles supplémentaires sur 3 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection