Marble Texture (Hueforge) (No AMS)

Intro: Hello, this is a marble texture that you can apply on your 3d prints. It requires two colors a gray (picture 4) and then a white. You can also replace the gray with black (picture 5). Instructions to use this model are as follows: Which file do I use? There are three different files for the marble texture. One is labeled as High TD, Mid TD and Low TD. If you know what TD is, then pick the respective stl for the TD of the white you are going to use. If you don't know what TD is, then it just means how see through your filament is. To find out which of the files above you should use, you should print out the “marble tester” stl. In it you will find 3 test swabs for the different TD files. Left most is low, middle is mid, right is high. After printing, whichever one looks the best to you, should be the one you use. Couple notes on printing it: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Swap Instructions: Start with Gray (or black) At layer #5 (0.