Thingiverse
Marcy Weight Bench Clip
door alexkazim
3
Downloads
2
Likes
0
Makes
This is a clip for a Marcy weight bench so you can change the weights on one side without the bar tipping over.
My weight bench came with an unweighted bar so changing large weights was a challenge since the bar would tip if it was unbalanced by more than 10 lbs. This clips onto the bar holder to keep the bar from tipping. I've tied it out to 40 lbs but I wouldn't push it too far.
The clip itself is an angled piece of plastic with a slot. When you're done, you can place it on a different part of the bar holder to keep it out of the way.
Since weights are heavy PLEASE USE AT YOUR OWN RISK.
My weight bench came with an unweighted bar so changing large weights was a challenge since the bar would tip if it was unbalanced by more than 10 lbs. This clips onto the bar holder to keep the bar from tipping. I've tied it out to 40 lbs but I wouldn't push it too far.
The clip itself is an angled piece of plastic with a slot. When you're done, you can place it on a different part of the bar holder to keep it out of the way.
Since weights are heavy PLEASE USE AT YOUR OWN RISK.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!