Thingiverse
Mario Block Tower
von Dino_and_TheKid
14
Downloads
12
Likes
0
Makes
Dice tower made of stacked blocks from Mario. I used the designs from A_SKEWED_VIEW_3D (https://www.thingiverse.com/thing:2947133),
DoctorNothing (https://www.thingiverse.com/thing:3438367),
and AndrewBougie (https://www.thingiverse.com/thing:1971969) to build this, because I am nowhere near as talented as them. The tray doesn't cover the whole tower when collapsed, it was just something I added quickly to help it stand and keep the dice controlled.
I don't remember the print settings, because it was a while ago that I printed it, but I'm sure that supports were definitely needed when printing. I'm sure I just did a basic .2 layer height and 15% infill.
I don't know what else to say about this. Don't forget to share with the class!
PLEASE do not sell any of your makes of this.
Don't forget to consider tipping if you enjoy this print and are capable of doing so!
DoctorNothing (https://www.thingiverse.com/thing:3438367),
and AndrewBougie (https://www.thingiverse.com/thing:1971969) to build this, because I am nowhere near as talented as them. The tray doesn't cover the whole tower when collapsed, it was just something I added quickly to help it stand and keep the dice controlled.
I don't remember the print settings, because it was a while ago that I printed it, but I'm sure that supports were definitely needed when printing. I'm sure I just did a basic .2 layer height and 15% infill.
I don't know what else to say about this. Don't forget to share with the class!
PLEASE do not sell any of your makes of this.
Don't forget to consider tipping if you enjoy this print and are capable of doing so!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!