Mario Box Bath Bomb

# Printing

Printed with 10% infill, supports and a brim to ensure corners don't lift. 3mf file attached should have the settings applied already.

I have also attached the .blend file in case you'd like to make updates to the original.

---

# Assembly
Assembling the box is pretty easy if you have your little helper with you. If not, then just place the sides marked with A and B respectively against the base. Once you place two corners together (and A and a B) then place tape around the edge - repeat for the other two sides. At this point I recommend adding a rubber band, or your kid's hair tie around the box **tightly** as you will be putting a lot of pressure in the box when packing it with the ingredients.

** Optionally leave the box disassembled until step 5 below, as you may want to add white for the question mark before packing the box. **

---

# Bath Bomb

Makes a bath bomb is roughly 2" in size.

I recommend a 12 hour minimum dry-time so that it pulls