Thingiverse
Mario question mark block planter
by Coenjo
7
Downloads
7
Likes
0
Makes
The inner dimensions of the pot are 110x110x90 mm (length x width x depth)
No supports required and printable at any infill.
Print the main cube once, then print the question mark and the dot 4 times.
The Question marks and dots can then be popped right into the blind holes on the outside of the cube and you're done.
No supports required and printable at any infill.
Print the main cube once, then print the question mark and the dot 4 times.
The Question marks and dots can then be popped right into the blind holes on the outside of the cube and you're done.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
