Mark5 O3 Analog Mod Kit

This print is designed to convert my previously released GEPRC MARK5 O3 version to an analog system.Any parts not included in the 3MF file can be downloaded and printed via the link below.The design was based on the RUSH Tank Solo VTX, but it should be compatible with most VTX units that use the M2 20×20 mounting pattern.https://makerworld.com/en/models/2168492-mark5-tpu-parts#profileId-2351620 This is the O3 version print part.It is designed with a lost buzzer housing that helps neatly organize and secure the camera cable. The O3 camera has a width of 20mm, while most analog cameras used on the MARK5 are 19mm wide.Therefore, the model has been newly redesigned to fit the 19mm camera standard.(The washers shown in the photos were temporarily installed because the bolts were slightly too long. They are VTX washers and do not require special attention.)The TANK SOLO features grooves on the bottom heatsink to improve airflow and enhance heat dissipation.I wanted to make sure this design f