Thingiverse
Marker holder for wall stand
von AlfaRo_1
0
Downloads
5
Likes
0
Makes
Holder for permanent markers. It is attached to the panel with 2 screws.
The cell size is 18x22 mm., suitable for placing large markers.
ABS was printed, does not require the use of supports.
The cell size is 18x22 mm., suitable for placing large markers.
ABS was printed, does not require the use of supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!