Marklin turnouts horizontal servo drivers

I designed those to fit the Marklin Left Hand turnouts (straight 24612 & curved 24672) as well as Right Hand turnouts (straight 24611 & curved 24671).
You will need a servo tester to adjust and record the pulse width for each end and stop to avoid binding (aka the servo keeps pushing with the slider in its maximum position). I created a jig (Servo Gear Position Base Plate) with a single tooth to align the wheel while the servo is set at 1500 micro-seconds (which is its mid-point). The goal was to be able to easily exchange the servo in case one goes bad, but in practice you still need to adjust the end points to avoid binding.
The servo is a tight fit and is held in place by a sliding clip that can easily be removed to replace the servo, even in a tight spot.