Thingiverse
MarmotteTfrontMount
von miromir237
0
Downloads
0
Likes
0
Makes
It is a simple merge of thing:3993056 and thing:3712955
I wanted to mount my antenna in the front of the quad. I had to cut out the print from the bottom in other to get the antenna in.
Due to this modification, I had to print with supports which I don't like for my Flexfill 98A (hard TPU). It's very difficult to get them out.
I wanted to mount my antenna in the front of the quad. I had to cut out the print from the bottom in other to get the antenna in.
Due to this modification, I had to print with supports which I don't like for my Flexfill 98A (hard TPU). It's very difficult to get them out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
