Slicer Discord
Mars Station Alpha – 3D-Druckmodell von Thingiverse Thingiverse

Mars Station Alpha

4 Downloads
11 Likes
0 Makes
Zum Modell
Mars Station Alpha

Since reanimating an atmosphere on Mars is not very feasible and to shuttle the amount of materials needed to build on-surface structures would be monumental I decided to make my station subterranean. By being below ground, it would be easier to maintain a living temperature, atmosphere, shelter from weather, less stress on structures and allow growth on demand. This concept is based on a two phase approach and tries to take advantage of existing terrain and resources. Essential to choose best crater location based on accessible buried ice and desired minerals.

Phase 1:
Land Nuclear Powered Mining Robots at chosen Crater Location. Programmed and remotely controlled (IE: Rovers), to mine for ice, minerals and to tunnel pathways and open spaces. Nuclear Power provides for continuous use 24/7.

Priorities for mining robots would be to find buried ice and minerals. These areas would be staged for second phase ramp up. Allow robots to tunnel and remove
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen