Thingiverse
Marshall Stanmore tweeter mounting plate
par mo_sm_86
2
Téléchargements
1
Likes
0
Makes
A simple mounting plate to replace blown tweeters in a Marshall Stanmore v1. It may be compatible with other models as well but i can't verify that.
Accepts ±38mm tweeters quite nicely (assuming they're round), I used Targa TG-3T's.
Three iterations total, v0.1 & v0.2 exist only for refining the final product and will not be uploaded.
Fits quite snugly into original cutouts and uses the same hole pattern.
I used hot glue to both hold the tweeters in place and as vibration dampening. Use an appropriate adhesive for whichever filament type you're using.
The 8 prongs act as anchor points for the adhesive. I did it this way to keep the vent slots clear all the way around.
Accepts ±38mm tweeters quite nicely (assuming they're round), I used Targa TG-3T's.
Three iterations total, v0.1 & v0.2 exist only for refining the final product and will not be uploaded.
Fits quite snugly into original cutouts and uses the same hole pattern.
I used hot glue to both hold the tweeters in place and as vibration dampening. Use an appropriate adhesive for whichever filament type you're using.
The 8 prongs act as anchor points for the adhesive. I did it this way to keep the vent slots clear all the way around.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
