Thingiverse
Mask Ear Protector
por Torgo
15
Descargas
15
Likes
0
Makes
A very quick to print ear protector/mask tightener for face masks. IF you print with concentric mode it’ll print in under 10 minutes.
You hook the strap of your mask onto one side, then put it behind your head and then hook the other side. This relieves pressure from your ears where the straps would normally sit, while tightening the fit of the face mask.
I hope you find this useful, I’ve already printed a few of these to keep next to my face masks. They’re quick enough that you can print one if you lose it too!
You hook the strap of your mask onto one side, then put it behind your head and then hook the other side. This relieves pressure from your ears where the straps would normally sit, while tightening the fit of the face mask.
I hope you find this useful, I’ve already printed a few of these to keep next to my face masks. They’re quick enough that you can print one if you lose it too!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
